Page Comparison

Everyone:

•  Figure out what part of the rocket you'll present for the CDR.

Modeling/Simulation:

•  Run motor simulation for final OpenRocket model(after parachute calculation is made and parachutes are updated), and put in CDR

Avionics:

•  Generate slides for the COTS avionics system
•  Overview of COTS avionics w/ James
•  (If pursuing) decide what the custom avionics board should be capable of.

CAD Designer:

•  Create entire CAD model for rocket, driven by OpenRocket model

Website/Media Designer:

•  Add team mission to website

Presentation Designer:

•  Create blank CDR slides for Thrust to Weight Ratio, OpenRocket Model, Fin Flutter calculations, CAD model, Parachute calculations, and anything else not listed that was in the PDR

BOM Maker:

•  Add parachute given by Numbers Person to BOM
•  Add coupler tubes to BOM
•  Add rocket motor to BOM

Numbers Person:

•  Calculate Thrust to Weight ratio for the rocket and add to the CDR
•  Calculate ideal parachute diameters, use this number to drive our parachute choice (from this website), and add all that info to the CDR
•  Give parachute choice to BOM Maker to add