Item | Who | Notes |
---|
Board updates |
|
|
Software | | Updates: - Sensor drivers written
- Onboarding
TODO: |
Radio Module | | Updates: - Added ESD to connectors
- Added UART jumpers to GPS and a debug bus
- Schematic updates "beautified"
- Board Ready for review
To-Do: |
Power Module |
| Updates: - Design voltage/current sense
- Select passives for most ICs
- Schematic is 60% complete
To-Do: - James May (RIT Student) Update Block Diagram to reflect current design
- James May (RIT Student) simulate umbilical switch in LTspice, look at power loss
- James May (RIT Student) Assemble BOM & include all components
- Create BOM file
- Add switcher
- Add switcher passives
- Add umbilical switch components
- Add monitoring components
- Add monitoring passives
- Add microcontroller
- Add microcontroller passives
- Add WIZnet
- Add WIZnet passives
- Add flash memory
- Add flash passives
- James May (RIT Student) Spec shielded inductors
- James May (RIT Student) Complete schematic capture
- Complete switcher design
- 5V switcher
- 3.3V switcher
- Backplane connector
- current measure
- voltage measure
- WIZnet
- Complete battery/umbilical switch design
- Battery/umbilical switch
- Programming interface
- Add microcontroller & logging circuitry (should be roughly identical to other modules)
- James May (RIT Student) Complete layout
- Place components
- Calculate power trace widths
- Route power traces
- Route signal traces
- James May (RIT Student) Simulate switchers in Webench
|
Sensor Module |
| Updates: - Started reviewing some schematics with JIM
- Continuing work on schematics
TODOs: - Updated block diagram
- All breakouts Ordered
- IC Schematics Reviewed
- MS5607
- BMP390
- ADXL375
- LSM6DSL
- LIS3MDL
- TMP117
- SHTC3
|
Connector spec |
| Idea 1: "Horned connectors" going sideways - Positively locking
- Board-edge would look very neat
- Board-edge would take up too much space - we have 130mm width, 60mm per board is not enough margin
Idea 2: |