- Payload structures
- Acrylic walls (4x)
- Steel structure (1x) ? not sure how to word this
- Chute bay (1x)
- Etched acrylic walls (4x)
- Structural Frame Assembly
- Internal Frame Assembly
- Plastic frame
- Video sled
- Tracking sled
- L-band holder
- Antenna holder R (2x)
- Antenna holder L (2x)
- Chute bay
- Parachute
- Flame blanket
- Charge caps (2x)
- Avionics bay structures
- End cap assembly
- Half coupler
- Sled 1
- Sled 2
- Sled 1 blank
- Sled 2 blank
- Big Red Bee holder
- Antenna holder (2x)
- 1-battery case (3x)
- Electronics
- BigRedBee (2x)
- RRC3 (4x)
- D-Sub Breakouts (6x)
- Batteries w/ XT60s (6x)
- DARWIN (2x)
- Video Transmitter
- RunCam
- USB Video receiver (2x)
- Spare batteries (2x)
- RF
- 70cm 433 MHz rubber ducky antenna
- 70cm whip antenna
- 900 Mhz "1/2 4 wave" cut antenna
- L-Band Patch GPS antenna (2x)
- Helical antenna (2x)
- Cloverleaf antenna (2x)
- Dipole 900 MHz antenna (2x)
- Yagi antenna
- SMA extenders (2x3x)
- Misc. Adapters TODO
- Baofeng UV-5R (TODO get a count on these)
- USB programming cable (1x)
- "phone" APRS cable (3x)
- Charging stations (TODO get a count on these)
- Ground Station
- Ground station
- Ethernet "short" orange (4x)
- Ethernet "medium" multicolor (3x)
- Teensy 4.1 w/ Ethernet kit
- Batteries (2x)
- Barrel cables (4x)
- Router power adapter (2x)
- Thinkpad laptop power adapter (2x)
- MicroUSB cable (3x)
- Keyboard
- Mouse
- Tools / Spare Material
- Screwdriver set
- Soldering iron
- Angle cutters aka wire strippers (2x)
- Pliers (2x)
- Electrical tape
-
hot glue - Sand paper
- Multimeter
- At least voltmeter and continuity
- Extra ground station grommets / dust plugs
- Velcro
- Zip ties
- Heat shrink
- Crimps / crimpers
- M5 SHCS bag (1x)
- Metric fastener set (1x)
- M3x10/25 set (1x)
- M3 standoff (male and female) set (1x)
{"serverDuration": 310, "requestCorrelationId": "f892734489e949bca8e69fcd3d46ae0e"}