Page Comparison

• Dante Sivo (RIT Student) Ben Hyman (RIT Student) - get Darwin mounting holes to Yev
  • basic dimensions - still need mounting holes
    • keep under 40mm wides (minor dimension)
      
• Will Merges (RIT Student) - figure out JLCPCB sponsorship
  • probably not going to use
    

 Yevgeniy Gorbachev (RIT Student) Billy Siegener (RIT Student) Aaron Chan (RIT Student) Will Merges (RIT Student)

Still to do:

• battery retention / location
• side wall mounting
  • recess side posts
• wiring diagram (high-level)
• connectors
• connect sleds (intra-sled connections)
  
  • ribbon cables on top
• mass looks good
  • estimated ~2300 grams without including side walls, electronics, recovery gear, batteries

Dante Sivo (RIT Student) Joseph Even (RIT Student) Seth Davidson (RIT Student) Jonathan Russo (RIT Student) Ben Hyman (RIT Student) Matthew Klein (RIT Student)