...
- Donovan Barros (RIT Student) Shrink central connecting bar to accommodate backplane modules
- Donovan Barros (RIT Student) Add DE-9 holes for both downward-facing connectors
- Donovan Barros (RIT Student) Expand DE-9 holes to accommodate square-ish connector
- Donovan Barros (RIT Student) Check DE-9 connector dimensions to make sure they fit in the holes (these are in)
- Donovan Barros (RIT Student) Update cut radii
- Donovan Barros (RIT Student) Change the dimensions of the BRB's battery inside the BRB model to match the larger battery
- Donovan Barros (RIT Student) Use shorter version of last year's battery holders (look cleaner)
- Yevgeniy Gorbachev (RIT Student) Saner battery layout
- Donovan Barros (RIT Student) Move RRC3s closer
...
- Donovan Barros (RIT Student) Design Finger Tech screw switch bracket (these are in)
- Donovan Barros (RIT Student) Design Big Red Bee bracket
- Donovan Barros (RIT Student) Look into mounting the screw switches to the COTS sled
- Donovan Barros (RIT Student) Design strain relief bracket for d-subs
- Yevgeniy Gorbachev (RIT Student) CAD battery and a holder
- Donovan Barros (RIT Student) Adjust COTS sled layout
- Join BRB to antenna directly
- Add new battery (should end up close to the upper end cap)
- Add hole in upper end cap for new battery connector
- Donovan Barros (RIT Student) Hole drilling jig
- Donovan Barros (RIT Student) Integration plan
- Yevgeniy Gorbachev (RIT Student) Figure out which battery for backplane
- Yevgeniy Gorbachev (RIT Student) Lay out radio module antennas
- Yevgeniy Gorbachev (RIT Student) Update power module with corrected version
...
- Backplane module cutouts
- Holes and fasteners
- CHECK: Antenna hole aligned
- CHECK: Antenna can be assembled
- CHECK: Battery hole aligned
- CHECK: Battery can be assembled
Manufacture
Prerequisites
- Router bits
- Superglue
- Donovan Barros (RIT Student) router training (probably with Jim)
...