...
- Donovan Barros (RIT Student) Design Finger Tech screw switch bracket (these are in)
- Donovan Barros (RIT Student) Redesign Big Red Bee bracket
-
Donovan Barros (RIT Student) Look into mounting the screw switches to the COTS sled - Donovan Barros (RIT Student)Design Design strain relief bracket for d-subs
- Yevgeniy Gorbachev (RIT Student) CAD battery and a holder
- Yevgeniy Gorbachev (RIT Student) Adjust COTS sled layout
- Join BRB to antenna directly
- Add new battery (should end up close to the upper end cap)
- Add hole in upper end cap for new battery connector
- Donovan Barros (RIT Student) Hole drilling jig
- Donovan Barros (RIT Student) Integration plan
- Yevgeniy Gorbachev (RIT Student) Figure out which battery for backplane
- Yevgeniy Gorbachev (RIT Student) Lay out radio module antennas
- Yevgeniy Gorbachev (RIT Student) Update PCBs from Altium
- Donovan Barros (RIT Student) Design updated long key
Finishing touches
- Backplane module cutouts
- Holes and fasteners
- CHECK: Antenna hole aligned
- CHECK: Antenna can be assembled
- CHECK: Battery hole aligned
- CHECK: Battery can be assembled
...
- Donovan Barros (RIT Student) Laser cut end caps
- Donovan Barros (RIT Student) Laser cut connecting bars
- Donovan Barros (RIT Student) Print antenna BRB bracket
- Donovan Barros (RIT Student) Print BRB bracketsmall battery holders
- Donovan Barros (RIT Student) Print battery holders (2x small / 1x large)large battery holder
Manufacturing (Final)
- Donovan Barros (RIT Student) Machine upper end cap
- Donovan Barros (RIT Student) Machine lower end cap
- Donovan Barros (RIT Student) Machine connecting bar
- Donovan Barros (RIT Student) Machine connecting bar
- Donovan Barros (RIT Student) Machine center bar
...
- Donovan Barros (RIT Student) Glue together components
- Donovan Barros (RIT Student) Drill holes in nosecone
- Donovan Barros (RIT Student) Glue in key