Page Comparison

...

Action items

General

Last week

This week

•  poster tomorrow
•  Tech report due May 13th or 15
•  Last update 22nd
•  OR confirm

Next week

Structures

Last Week

•  FDR
•  Start sanding tubes
•  1 bulkhead finished
•  If fiberglass is here then layup nose cone
•  Cut tubes to length
•  redo bulkhead FEA 
•  Research into layups for learning
•  Machine Bulkheads
•  Sand tubes to length
•  explore nose cone lay up options
•  Look into fin stabilizing options
•  Fin can CAD
•  Finish tubes with epoxy layer 
•  Make new nose cone
•  Cut fins
•  Fin can 3d print
•   FIN CAN DONE
•  Fin machine rectangles
•  

This week

•  Bulkhead holes for avionics
•  cut fin slots in booster
•  TOTALLY finish the tube surfaces
•  All tubes fit together
•  nose cone fit 
•  confirm OR stuff 
•  Finalize masses (make sure we get 5lbs)

Next week

•   IREC 101
•   Paint
•  everything else tbh

Payload

Last week

•  Making parashot bay
•  Darwin progress- joe approved/redesign 
•  Order part with approval
•  FDR SLIDEs IN
•   Payload lid machined
•  Welding parashot bay
•  Assemble Darwin
•  Waiting on Darwin and screw switches

This week

•  Welding parashot bay Assemble more Darwin
•  General GS stuff
•     Waiting on Darwin and wire screw switches

Next week

•   Continue Darwin 
•  And loose end stuff
•  General GS stuff
•  deployment testing eventually

Avionics

Last week

•  Order ave bay parts
•  FDR SLIDES IN
•  Waiting for FG tube
•  All flying electronics are in
•  Parts sent to matt for print
•  Xbee module Worked on
•   

This week

•  waiting antenna 
•  find more cables
•  MS561 barometer/temp sensor worked on
•    finishing up ave bay cad

Next week

•  Assembly of bay
•  Vacuum test flight computers (waiting for whole bay)

...