4/6/2023 - 4/13/2023

Subteam	Action Items	Further Action Items	FUrther Further action itesm
Structures	Finish nose cone bondo sand poly drill holes need jig for payload vent holes in parachute bay shear pins vent holes in av bay screw holes for couplers fix tip keying tabs stability analysis	Drill payload holes drill vent holes drill screw holes drill shear pin holes prime nose cone reweigh EVERYthing	Weigh everything tape off all holes and aluminum for paint screws in nosecone get Alex RGB code get rocket painted keying geometry packing list
Avionics	get new connectors for BRB battery make connectors make wiring harness vacuum test avionics cut av bay route delrin end caps laser support bars test brackets for batteries and connect print screw switch brackets print backplane battery bracker integration guide order tamiya Get FRS radio	Recut COTS sled Cut key Design and print PROMPT mount Vacuum test Design and print d-sub bracket Set pinout Bridge breakouts	Recut COTS sled strain relief bracket (dsubs) debur, sand, and glue bay keying geometry test prompt mount RRC3 battery test integration testing, practice edit last years procedure and improve packing list
Backplane	fix radio module order power module putting altimeter in place of backplane need weight for test launch flying the battery for backplane Testing RFM range at test launch	RFM code Design and cut small altimeter sled waiting for parts dead mass for test flight	modules in modules need to be assembled figure out antenna splitter situation Range test RFM
Payload	Av bay BRB needs standoffs and mount Print SABOT print FC mount and add heat inserts print battery mount and mount x2 print scrap mount and mount make dummy scrap with ultralogger -Jim 3D print screw switch mount tap support bar 3D print antenna clips reduce weight in chute bay Assemble and wire COTS Av -Louis Write procedures	Print sabot reprint scrap mount hole jig integrate new BRB battery make new mount Reintegrate other battery integration procedures	Reprint sabot print final scrap mount Integrate BRB Battery write procedure payload 2 being machined weld payload 2 bay test electronics and recovery this weekend do software test load calls and payload opening/closing talk to consultant James about recovery
Recovery	Deployment testing Thursday night Assemble recovery harness test remaining TD-2s Main parachute bag test how easy does it stay in there? how easy does it pull out Write and PRACTICE integration procedures Figure out stringing	Deployment testing finish procedures	main pull testing
Poster			done
Test Flight		Pros	Cons
Other			Write tech report figure out video meeting with esra Alex Speyer (RIT Student)