2021-10-04 Meeting Notes - VOID

• Dante Sivo (RIT Student) Ben Hyman (RIT Student) - get Darwin mounting holes to Yev
  • basic dimensions - still need mounting holes
    • keep under 40mm wides (minor dimension)
      
• Will Merges (RIT Student) - figure out JLCPCB sponsorship
  • probably not going to use
    

 Yevgeniy Gorbachev (RIT Student) Billy Siegener (RIT Student) Aaron Chan (RIT Student) Will Merges (RIT Student)

Still to do:

• battery retention / location
• side wall mounting
  • recess side posts
• wiring diagram (high-level)
• connectors
  • spade connectors for going to recovery section (charges)
    • wire epoxied in plate, female spades crimped to each end
• connect sleds (intra-sled connections)
  
  • ribbon cables on top
• mass looks good
  • estimated ~2300 grams without including side walls, electronics, recovery gear, batteries
• GPS antenna for BRB
  • BRB on inside, camera board on outside
  • whip and GPS antenna (nay-nay) on outside above camera board

Dante Sivo (RIT Student) Joseph Even (RIT Student) Seth Davidson (RIT Student) Jonathan Russo (RIT Student) Ben Hyman (RIT Student) Matthew Klein (RIT Student)